A-A-52512
2.18 Riveted connections. Riveted connections shall be in accordance with SAE J492. Rivet holes shall be accurately punched or drilled and shall have the burrs removed Rivets shall completely fill the holes Rivet heads shall be full, neatly made, concentric with the rivet holes, and in full contact with the surface of the member.
2.19 Instructions plates. Each winch shall be equipped with instruction plates or diagrams, including warnings and cautions, describing any special or important procedures to be followed in assembling, operating, or servicing the winch. Letters shall be capitols and numbers shall be Arabic or alternate Gothic no. 2 or equivalent type face, unless otherwise specified (see 5.2).
Ownership designation and the words “SHIPPING DATA FOR”, “CAUTION” and “WARNING” shall be not less than 24-point type and all other letters shall be not less than 6 points unless otherwise specified (see 5.2). Layout of plates shall be as specified in the contract or order (see 5.2). Plates shall be attached by screws, bolts, or rivets in a location that is readable from the typical operating position.
2.20 Identification and markings. Identification and markings shall be permanent and legible and shall include as a minimum, the manufacturer’s identification code (CAGE), the part or identification number (PIN) A52512-1, the national stock number (NSN), and the winch capacity.
2.21 Finish treatment. The portions of the winch normally painted shall be cleaned, treated and painted to provide protection against rust corrosion and deterioration. If Chemical Agent Resistant Coating (CARC) is required, it shall be specified in the contractor order (see 5.2). The color of the paint final coat shall be as specified in the contractor order (see 5.2).
2.22 Interchangeability. All parts having the same part number shall be functionally and dimensionally interchangeable. Interchangeable parts are defined as two or more parts possessing such fictional and physical characteristics to be equivalent in performance and durability and capable of being exchanged one for the other without alteration of the parts themselves or of adjoining parts except for adjustments and without selection for fit or performance.
3. QUALITY ASSURANCE PROVISIONS.
3.1 Responsibility for inspection. The contractor is responsible for the performance of all inspections (examinations and tests).
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business