MIL-PRF-l2065E
3.7 Treatment and pa inting. The portions of the winch normally painted shall be cleaned,
treated, and painted in accordance with MIL-T-704, type A (see 4.3.1).
4. VERIFICATION
4.1 Class ification of inspection. The inspection requirements specified herein are
classified as follows:
a. First article inspection (see 4.2).
b. Conformance inspection(see 4.3).
4.2 First article inspection.
4.2.1 Examination. The winch shall be examined as specified in 4.3.1. Presence of one
or more defects shall be cause for rejection.
4.2.2 Tests. The winch shall be tested as specified in 4.3.2. Failure of any portion of the
test shall be cause for rejection.
4.2.3 First article model. Any changes or deviations of production winches from the
approved first article model during production will be subject to the approval of the contracting
officer. Approval of the first article model will not relieve the contractor of his obligation to
furnish winches conforming to this specification.
.
.
4.3 Conformance inspection. The manufacturer shall utilize all its commercial
production quality control procedures for the winches produced for the government. In addition,
prior to shipment, the contractor shall examine each winch for the defects listed in table II.
4.3.1 Examinination. The winch shall be examined for the following defects in table II.
Examination shall be visual, tactile or by measurement with standard inspection equipment
(SIE).
6
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business