MIL-PRF-12065E
6. NOTES
(This section contains information of a general or explanatory nature which maybe
helpful, but is not mandatory.)
6.1 Intended use. The winch is intended for use in pulling loads where light weight and
compactness are required or power is not available.
6.2 Acquisition requirements. Acquisition documents must specify the following:
a. Title, number and date of this specification.
b. Size, PIN, and quantity of winches required (see 1.2 and 6.3).
c. Issue of DODISS to be cited in the solicitation, and if required, the specific issue
of individual documents referenced (see 2.2.1 and 2.3).
d. When a first article inspection is required (see 3.1).
e. When wire rope other than as specified is acceptable (see 3.4.5).
f. When mounting hole requirement for the 5-ton size winch should be as specified
in 3.4.8.
g. Packaging requirements (see 5.1).
..
6.3 Part or Identifying Number (PIN) . The PIN to be used for winches acquired to this
specification are created as follows:
M
12Q65 XXX
Size (see 1.2)
Examples: 2.0 = 2 tons, 3.5=3 1/2 tons
Specification number
Prefix for Military Specification
6.4 First article model. Any changes or deviations of production winches from the
approved first article model during production will be subject to the approval of the contracting
officer, Approval of the first article model will not relieve the contractor of his obligation to
furnish winches conforming to this specification.
8
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business