INCH-POUND
MIL-PRF-29250C
24 June 1997
SUPERSEDING
MIL-L-29250B(YD)
9 May 1994
PERFORMANCE SPECIFICATION
LOADING JACK SYSTEM, ISO CONTAINER
This specification is approved for use by all Departments and Agencies
of the Department of Defense.
1. SCOPE
1.1 Scope. This specification covers the International Organization of Standardization (ISO)
container loading jack system (ILJS) which is used to provide level loading and unloading on
aircraft. The ILJS also is used to provide on and off loading of 102-inch (2 591 millimetre (mm))
wide flatbed trailers and all 25K-loaders, and mobility and maneuverability for freight containers
having ISO corner fittings (hereinafter referred to as ISO containers).
1.2 Classification. The ILJS will consist of four corner jack assemblies attachable to top and
bottom ISO corner fittings for ISO containers (see 6.1).
2. APPLICABLE DOCUMENTS
2.1 General. The documents listed in this section are specified in sections 3 and 4 of this
specification. This section does not include documents in other sections of this specification or
recommended for additional information or as samples. While every effort has been made to
ensure the completeness of this list, document users are cautioned that they must meet all
specified requirements documents cited in sections 3 and 4 of this specification, whether or not
they are listed.
Beneficial comments, recommendations, additions, deletions, clarifications, etc. and any data
which may improve this document should be sent to: Commanding Officer (Code 15E2), Naval
Construction Battalion Center, 1000 23rd Avenue, Port Hueneme, CA 93043-4301, by using the
Standardization Document Improvement Proposal (DD Form 1426) appearing at the end of this
document or by letter.
AMSC N/A
FSC 3950
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business